Step by Step Process Whitelist
Last updated
Was this helpful?
Last updated
Was this helpful?
For participants who are registered in the Whitelist.
Go to Gondar Protocol website, then click on "APP" and it will redirect you to the Pools section, where you can find that IDO is active, in progress or finished.
You select the IDO to which you are going to participate in "DETAILS" and it will redirect you to the participation section. In this section you must click on the "Connect Metamask" button, with the correct network according to each IDO, otherwise it will not let them link your account with the LaunchPad. This section shows the general data of your account, if you are on the Whitelist list or not, and the maximum allocation. In addition, the general information of the IDO, the Project information and the calendar are shown at the bottom.
Once linked you will be able to see if they are on the Whitelist list or not yet. If you are not on the whitelist yet, you should check if the whitelist competition for their project is still enabled. Otherwise you will not be able to participate in this process. On the other hand, if you are in the Whitelist you must wait for the LaunchPad to start, you can see the information at the bottom of the section (see step 1).
Once the IDO starts, you will need to connect your meta mask to the LaunchPad, and only if you are whitelisted will you be able to see that the pool is open and a green indication. To start the process you must click on "The Pool is Open".
Once inside, you will be able to see the time remaining for the IDO to finish, the contribution section, the IDO progress bar, and the token redemption section.
According to the allocation, to contribute in this case you must put the amount in "BNB" in the "Amount BNB" box and the "Send BNB" button will be activated, and below these boxes the amount of tokens that correspond to the amount of BNB you are putting, to send this amount you must click on "Send BNB". If you put an amount below "Min. Allocation" or above "Max. Allocation", it will not allow you to submit your contribution to the IDO.
Once the BNB have been sent, the progress bar will be updated, and also the "Claim Tokens" section, where you can see the amount of tokens they bought distributed according to the vesting of each project.
Once the time of the IDO is over, a message appears where you can see your contribution. This message also appears when the progress bar reaches 100%, the whole process will finish.
Then, the following message will appear when you want to enter again to verify the IDO: "The pool is closed, wait for you to remove your tokens", this will be activated when the tokens are unlocked, according to the vesting of each project.
Once the tokens have been unlocked for the first time, the section to enter to claim the unlocked tokens will be enabled by clicking "Enter to withdraw your tokens".
After entering this section, you will be able to see your total contribution, the IDO progress bar (the number of tokens that were sold versus the total) and, most importantly, the "Claim tokens" section, with the first unlocked tokens enabled. To claim the tokens of the first vesting, you must click on "Claim tokens".
Once the tokens have been claimed, the amount that corresponds to the first token lock will be 0, this means that you have already claimed your tokens and they are in your wallet. And with this, the process would end, for the unlocks, according to the vesting time of each project, they will be able to enter the LaunchPad and claim them in the predetermined deadlines.
Your GND tokens will be available in your wallet when you do all these steps.
